Floppy disk notcher addon
ezContents 23 August 2023
3D print your own 5 1/4 inch floppy disk notcher add-on.
MiSTer - 3D printed case
ezContents 7 December 2019
To house my set of MiSTer PCBs boards, which are: IO Board v5.6, SDRAM extra slim (XS), USB Hub v2.1 connected with USB Bracket with L-shaped connector, I wanted to 3D print a case. Unfortunately I could not find a design one that met all my needs, so I decided to remix existing Thingiverse designs and combine them into this case.
Printing with ABS
ezContents 29 March 2017
The most important advantages of ABS are impact resistance and toughness. Lego is made from ABS. It will also not deform in hot water, compared to PLA. On the downside ABS is hard to print. You need very hot printbed (around 110 degrees Celsius) and Kapton tape, so the first layer will stick properly. ABS can also warp and curl. There are also other issues in the Marlin firmware that need some attention.
3D printed USB arcade joystick enclosure
ezContents 11 December 2016
Important part in an electronic project is creating an enclosure for the parts. Without it, it is simply not finished. Luckily we now have 3D design software and 3D printers which are perfectly suited for the job.