Testing ABS-Like Resin V2

I was testing the ABS-Like V2 resin from Anycubic. 

On the pictures you can see that I have printed the Resin XP2 validation model. The exposure time of my Creality LD-002H mono resin printer was set to 2.5 seconds, which is a bit too long. 

I took this value from the Anycubic page of the resin for the Proton mono, which should be equivalent to my (old) Creality printer. On the next test print I am going to try to print with shorter exposure time. 

Nevertheless the resin prints well with no further issues. I would probably not print LEGO bricks with it, but it can take quite a bent until it snaps.